![]() Conveyor Clamp 1: This is a clamp that can be added to the conveyor rail figure in order to make an assembly line look and feel. You can mount the conveyor rail and tracks to the floor or ceilings for added interest. The ceilings have a right and left side slanting portion so you can have an angled ceiling look and feel. Positioning another building in its place. You can stack several of these building models end to end to create a long assembly line look and feel by dropping one of the end walls out of view and There is a moveable front and rear wall with posable door that moves up and down. It has right and left hand wall segments that can be dropped out of view for good camera viewing angles. Building: This is the main facility/building model. There are sizing morphs built into the pad and railings. You can place these against the edge walls of the building for added interest. Building Pad: This is an elevated pad with built in railings. This allows light to pass through the figures without casting a shadow. If you not proficient with lighting, the no shadow library has all the shadow casting ability turned off on all the elements. ![]() Note: There are two libraries for the Building elements/figures, a shadow and no shadow version. Poser version is available (sold separately) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |